Modeling regional aerosol and aerosol precursor variability over California and its sensitivity to emissions and long-range transport during the 2010 CalNex and CARES campaigns

TitleModeling regional aerosol and aerosol precursor variability over California and its sensitivity to emissions and long-range transport during the 2010 CalNex and CARES campaigns
Publication TypeJournal Article
Year of Publication2014
AuthorsFast J.D, Allan J., Bahreini R., Craven J., Emmons L., Ferrare R., Hayes PL, Hodzic A., Holloway J., Hostetler C., Jimenez JL, Jonsson H, Liu S, Liu Y., Metcalf A., Middlebrook A., Nowak J., Pekour M., Perring A., Russell L., Sedlacek A., Seinfeld J., Setyan A., Shilling J., Shrivastava M., Springston S., Song C, Subramanian R., Taylor J.W, Vinoj V., Yang Q., Zaveri R.A, Zhang Q.
JournalAtmospheric Chemistry and Physics
Date Published2014/09
Type of ArticleArticle
ISBN Number1680-7316
Accession NumberWOS:000341993100034
Keywordsairborne particulate matter; basis-set approach; carbonaceous aerosol; los-angeles basin; mexico-city; optical-properties; pm10/pm2.5 air-quality; secondary organic aerosol; spectral-resolution lidar; united-states

The performance of the Weather Research and Forecasting regional model with chemistry (WRF-Chem) in simulating the spatial and temporal variations in aerosol mass, composition, and size over California is quantified using the extensive meteorological, trace gas, and aerosol measurements collected during the California Nexus of Air Quality and Climate Experiment (CalNex) and the Carbonaceous Aerosol and Radiative Effects Study (CARES) conducted during May and June of 2010. The overall objective of the field campaigns was to obtain data needed to better under-stand processes that affect both climate and air quality, including emission assessments, transport and chemical aging of aerosols, aerosol radiative effects. Simulations were performed that examined the sensitivity of aerosol concentrations to anthropogenic emissions and to long-range transport of aerosols into the domain obtained from a global model. The configuration of WRF-Chem used in this study is shown to reproduce the overall synoptic conditions, thermally driven circulations, and boundary layer structure observed in region that controls the transport and mixing of trace gases and aerosols. Reducing the default emissions inventory by 50% led to an overall improvement in many simulated trace gases and black carbon aerosol at most sites and along most aircraft flight paths; however, simulated organic aerosol was closer to observed when there were no adjustments to the primary organic aerosol emissions. We found that sulfate was better simulated over northern California whereas nitrate was better simulated over southern California. While the overall spatial and temporal variability of aerosols and their precursors were simulated reasonably well, we show cases where the local transport of some aerosol plumes were either too slow or too fast, which adversely affects the statistics quantifying the differences between observed and simulated quantities. Comparisons with lidar and in situ measurements indicate that long-range transport of aerosols from the global model was likely too high in the free troposphere even though their concentrations were relatively low. This bias led to an over-prediction in aerosol optical depth by as much as a factor of 2 that offset the under-predictions of boundary-layer extinction resulting primarily from local emissions. Lowering the boundary conditions of aerosol concentrations by 50% greatly reduced the bias in simulated aerosol optical depth for all regions of California. This study shows that quantifying regional-scale variations in aerosol radiative forcing and determining the relative role of emissions from local and distant sources is challenging during 'clean' conditions and that a wide array of measurements are needed to ensure model predictions are correct for the right reasons. In this regard, the combined CalNex and CARES data sets are an ideal test bed that can be used to evaluate aerosol models in great detail and develop improved treatments for aerosol processes.

Short TitleAtmos. Chem. Phys.
Student Publication: